For those unfamiliar, once installed, the Advanced Elements Accessory Frame allows one to add any aftermarket 1” rail-mount, and customize with your choice of rod holders, a fish finder, camcorder, cameras or other equipment. The Accessory Frame System can be installed on most Advanced Elements inflatable kayak models as well as many other boats providing enough deck space is available. (The frame requires 22” wide for the front grommets and 23” wide for the rear grommets.) As an added convenience, this kit comes with 2 sets of 4 grommets, allowing one to use it on two different kayak or to set up two locations on one kayak.
Besides the kit (which includes the accessory frame, 8 mounting grommets, application glue, cutting mat and instructions) to install it on the “cloth-based” kayak, you will also need an Exacto or matte knife with a new blade, fabric chalk or pencil, metal straight edge ruler, scotch tape, duct tape and four sheets of 5′ X 5″ cardboard.
First, inflate your kayak so that the Accessory Frame can be correctly positioned.
Layout the three bars – main center and two side arms.
Slide two mounting grommets onto the main frame body, and one mounting grommet onto each of the detachable arms. Attach the arms to the center bar.
Position the included “mounting templates” underneath the grommets, then align the shapes, starting with the front grommets (nearest the push pins on the assembly frame). Then slide the rear grommets (on the detachable arms) as needed to align them to the template. Once aligned, use scotch tape to keep them in place under the grommets – tape in such a way that it will be easy to remove without damaging the templates.
Place the assembled accessory frame on the kayak in the desired position, taking into account your paddling techniques and arm reach. Rotate the grommets as necessary to conform to the contours of the boat. Use a pencil or fabric chalk to mark the corner edges of the templates onto your boat.
Taping the template into position: Remove the template, and reposition directly on the kayak. Use your pencil/chalk to mark the position of the two rectangles in the middle of the templates onto the deck of your boat. Remove the templates. Place the included cutting mat under the deck of the kayak, between the hull upper and main bladder – this protects the main bladder from being cut.
Cutting the hole: Use your Exacto/Matte knife to cut out the marked rectangles on the deck of your kayak. Repeat on the other side.
Position the grommet through the hole: Position each mounting grommet through the cut rectangles.
Install the Frame before gluing to ensure proper placement: Assemble the Accessory Frame through the grommets, to ensure proper placement before gluing.
Remove the frame and grommets. Place your four sheets of cardboard on the inside of your kayak deck and position them under each of the rectangular holes.
Apply glue, one grommet installation at a time: Starting with ONE Mounting Grommet at a time, in a well-ventilated area, apply glue evenly around the top of the disk. Position the Mounting Grommet with glue, so that it is popping up through the hole of your deck. With cardboard in place, put your hand underneath the sheet of cardboard. Apply pressure to flatten out the grommet disk, making sure that the disk is in full contact with the deck material of the kayak. (Ruud ensures a good bond using a clamping system).
Apply pressure: Remove your hand from under the cardboard and apply duct tape around the perimeter of the grommet hole on the outside of the kayak. Make sure the duct tape flattens out the material around the base of the grommet, ensuring good contact between the material and the grommet disk.
Ensure proper placement before gluing: Repeat steps 2-4 for the next three Mounting Grommets. Leave the glue to cure for at least 12 hours before installing the Accessory Frame for use.
A happy kayak owner: Once the glue has dried, remove the duct tape, install the Accessory Frame, and you are ready to go!
