We may earn a commission when you buy through our links, at no extra cost to you.
RAM 2500 Kayak Rack Buying Guide
I’ve owned a RAM 2500 for six years and used it to haul kayaks to lakes, rivers, and coastal launch sites across half a dozen states. It took me longer than I’d like to admit to figure out the right rack setup for this truck. This buying guide covers everything I learned — sometimes the hard way — so you can skip the mistakes and get straight to the paddling.
Bed Carry vs Cab Roof Carry on the RAM 2500
This is the first question anyone with a RAM 2500 should answer before they buy a single piece of rack hardware. The truck gives you two real options: carry the kayak in the bed using a bed rack system, or strap it to the cab roof using a crossbar and J-rack setup. They are not equally good options, and the right answer depends almost entirely on how long your kayak is.
For kayaks over 10 feet — which covers most recreational sit-on-tops, touring boats, and fishing kayaks — the bed is almost always the better choice. Loading height at the bed rail is dramatically more manageable than the RAM 2500 cab roof. I spent my first two seasons loading a 14-foot touring kayak onto the cab roof solo and paid for it with a nagging right shoulder that bothered me all winter. The day I switched to a bed rack system was the day paddling stopped feeling like a chore before it even started.
Cab roof carry makes sense for kayaks under 10 feet, or in situations where the bed is already occupied by camping gear, coolers, or equipment for the trip. A short recreational kayak on a properly rigged cab roof rack is a clean and aerodynamic setup. Just go in with your eyes open about the loading height on this truck.
Why the RAM 2500’s Height Changes Everything
The RAM 2500 Heavy Duty sits noticeably higher than the RAM 1500, and significantly higher than most SUVs and crossovers. With factory ride height, the cab roof on a Crew Cab 2500 is somewhere between 77 and 80 inches above the ground. That is a long way up when you are standing in a parking lot holding one end of a 65 lb kayak.
The solution I settled on for cab roof carry was the Yakima ShowDown tilting cradle. It brings the loading point down to vehicle-side height so you place the kayak in comfortably, then tilt it back horizontal for transport. That single piece of hardware changed the whole experience. For bed carry, the height is much more manageable, but a 90 lb fishing kayak is still a 90 lb fishing kayak — if you load heavy boats solo regularly, look seriously at the TOOENJOY lift assist system.
What to Look For in a RAM 2500 Kayak Rack
Load capacity: Most J-rack sets are rated between 75 and 150 lbs per pair. For two heavy fishing kayaks, confirm the combined weight stays within the system rating. The Yakima OverHaul HD bed rack is rated at 300 lbs total — the highest of any system in this guide.
No-drill installation: On the RAM 2500, the OverHaul HD’s clamp-to-rail system is the right call — no holes, no regrets, and you can remove it in 20 minutes when you need the full bed for something else.
Fold-flat design: On a truck as tall as the RAM 2500, J-bars standing upright when empty create unnecessary wind drag and can clip garage entry beams. Fold-flat designs collapse to near-horizontal between uses. It sounds like a minor detail until you hear the scrape the first time you forget to fold them before pulling into the garage.
My Honest Recommendation for RAM 2500 Owners
If I were starting fresh with a RAM 2500 and a new kayak, here is exactly what I would buy: the Yakima OverHaul HD bed rack system first, then a J-rack accessory suited to my paddling style, and the ShowDown tilting cradle for any cab roof solo loading. The FORWODE 2-pair is the right pick for anyone who always loads with a partner and wants to keep things simple and affordable. Whatever setup you choose, always run bow and stern tie-down straps to the truck frame before every highway run.